Contact TAMCO Customer Service for configurations not shown.
ONE-SECTION
VERTICAL BLADE DAMPER
TWO-SECTION
VERTICAL BLADE DAMPER
Single-section vertical blade dampers must be installed so that linkage is at the top.
The actuator must be mounted on the drive rod which extends beyond the bottom of the damper
Multiple sections cannot be linked. Actuators must be connected to each section
The base of the damper must be extremely well supported.
The customer must specify that the damper will be installed in a vertical position. Our production software will adjust the configuration automatically.
There is no predetermined maximum blade length. Contact the factory for details.
TAMCO will honor its warranty if all of the above instructions are adhered to at the time of order and installation.
